石油化工高等学校学报

石油化工高等学校学报 ›› 2008, Vol. 21 ›› Issue (4): 55-58.

• 化工机械 • 上一篇    下一篇

泵用机械密封端面摩擦因数试验研究

魏龙1,2 , 顾伯勤1 , 孙见君3 , 冯秀1   

  1. (1 .南京工业大学机械与动力工程学院, 江苏南京210009 ;2 .南京化工职业技术学院, 江苏南京210048;
    3.南京林业大学机电工程学院, 江苏南京210037
  • 收稿日期:2008-02-26 出版日期:2008-12-20 发布日期:2017-07-05
  • 作者简介:魏龙(1972 -), 男, 江苏南京市, 副教授, 博士研究生
  • 基金资助:
    江苏高校高新技术产业发展项目(JH B05-29);南京市科技发展计划项目(200603009);江苏省“ 六大人才高峰”资助项目(07 -D-027

Experimental on Friction Factor of End Face Mechanical Seals for Pumps

WEI Long1,2GU Bo-qin1SUN Jian-jun3, FENG Xiu2   

  1. (1. College of Mechanical and Power Engineering, Nanjing University of Technology, Nanjing Jiangsu 210009, P.R. China; 2. Nanjing Chemical Engineering Technical College, Nanjing Jiangsu 210048, P.R. China; 3.College of Mechanical and Electronic Engineering, Nanjing Forestry University, Nanjing Jiangsu 210037, P.R. China)
  • Received:2008-02-26 Published:2008-12-20 Online:2017-07-05

摘要: 泵用机械密封在运行过程中最常见的现象是端面间的摩擦, 端面的摩擦因数是表征摩擦特性的关键
参数。从微观角度探讨了机械密封端面摩擦因数与摩擦状态的关系。在自行研制的机械密封计算机辅助试验装置
上对泵用GY70 型机械密封的端面摩擦因数进行了试验研究。结果表明, 随着弹簧比压的增大, 摩擦因数增大;当弹
簧比压较小时, 随着转速的增大, 摩擦因数以较快的速度增大, 当弹簧比压达到0.086 6 M Pa 后, 转速对摩擦因数几
乎无影响;当转速及弹簧比压都较小时, 介质压力对摩擦因数的影响很小, 当转速较大或弹簧比压较大时, 随着介质
压力的增大, 摩擦因数减小。

关键词: 泵 , 机械密封 , 摩擦因数 , 摩擦状态

Abstract: The friction of the seal faces was the most important phenomenon in working process of mechanical seals for pumps. The friction factor was a key parameter for expressing the friction state of the seal faces. The relationship between friction factor and friction state of the end faces of mechanical seals was discussed from a microscopic point of view. On the self-designed computer aided testing device of the mechanical seal system, the friction factor of GY70 mechanical seal used for pumps was tested. The test results indicate that the bigger the spring pressure, the bigger the friction factor. When the spring pressure is less, the bigger [KG*4]the rotational speed, [KG*4]the [KG*4]bigger the friction factor. [KG*4]But [KG*4]when the spring pressure [KG*4]reaches about 0.086 6 MPa, the friction factor is not almost influenced by the rotational speed. When the rotational speed and spring pressure are less, the medium pressure has a less influence on the friction factor. When the rotational speed or spring pressure is bigger, the bigger the medium pressure, the less the friction factor.

Key words: Pumps ,  Mechanical seal , Friction factor ,  Friction state

引用本文

魏龙, 顾伯勤, 孙见君,冯秀. 泵用机械密封端面摩擦因数试验研究[J]. 石油化工高等学校学报, 2008, 21(4): 55-58.

WEI Long, GU Bo-qin, SUN Jian-jun, FENG Xiu. Experimental on Friction Factor of End Face Mechanical Seals for Pumps[J]. Journal of Petrochemical Universities, 2008, 21(4): 55-58.

使用本文

0
    /   /   推荐

导出引用管理器 EndNote|Ris|BibTeX

链接本文: https://journal.lnpu.edu.cn/syhg/CN/

               https://journal.lnpu.edu.cn/syhg/CN/Y2008/V21/I4/55