热处理对Inconel718镍基合金组织及耐蚀性能的影响

doi:10.3696/j.issn.1006-396X.2009.04.017

石油化工高等学校学报 ›› 2009, Vol. 22 ›› Issue (4): 67-71.DOI: 10.3696/j.issn.1006-396X.2009.04.017

热处理对Inconel718镍基合金组织及耐蚀性能的影响

宋宜四,高万夫,胡卓婵

中国石油大学材料科学与工程系

收稿日期:2008-12-19 修回日期:2009-04-19 出版日期:2009-12-25 发布日期:2009-12-25
作者简介:宋宜四(1965 -), 男, 江西高安市, 在读博士
基金资助:
国家自然基金资助(50601029)。

Influence of Heat Treatment on Microstructure and Corrosion Resistant Performance of Inconel718 Nickel-Base Alloy

Department of Materials Science and Engineering,China University of Petroleum,Beijing 102249,P. R. China

Received:2008-12-19 Revised:2009-04-19 Published:2009-12-25 Online:2009-12-25

摘要/Abstract

摘要： 研究了Inconel718合金在940¹ 000℃固溶以及固溶+时效处理(720℃保温8 h后经50℃/h冷却到620℃保温8 h)后的组织及性能之间关系。结果表明,固溶处理后合金的硬度随着温度的升高而减小。固溶+时效处理后合金的硬度随着温度的升高先是增大再减小,到980℃时达到最大值,且硬度值比仅固溶处理的增加约1倍。在用H2SO4溶液调节pH值(pH=3)的体积分数为5%Na2SO4酸性溶液中测试极化曲线和交流阻抗,结果表明,固溶+时效处理样品的耐蚀性比仅固溶处理的差。在模拟高温高压H2S/CO2应力腐蚀环境试验测试结果表明,固溶处理和固溶+时效处理的样品耐H2S/CO2应力腐蚀性能均较好。

关键词: Inconel718镍基合金 , 热处理 , 组织 , 耐蚀性能

Abstract: The relation between microstructure and corrosion resistant performance on Inconel718 nickel-base alloy which were solution treated at 940～1 000 ℃ as well as solution treated and then aged at 720 ℃ for 8 h,50 ℃/h cooling and 620 ℃ for 8 h,was researched.The result show that the rigidity of alloy declined with solution temperature increasing.After solution and aging,the rigidity of alloy raised firstly then declined with temperature increasing,and reached the maximum at 980 ℃,the rigidities were the double of solution.Polarization curve and Alternating Current impedance were tested in 5% Na2SO4 acidity liquor which was regulated to pH of 3 with H2SO4 liquor.The result indicate that the corrosion resistant performance of samples which is solution treated and aged is worse than solution treated only.The simulation test at the high temperature and pressure H2S/CO2 stress corrosion condition indicated that the H2S/CO2 stress corrosion resistant performance of samples which are solution treated as well as solution treated and aged are both good.

Key words: Inconel718 nickel-base alloy , Heat treatment , Microstructure , Corrosion resistant performance

宋宜四,高万夫,胡卓婵. 热处理对Inconel718镍基合金组织及耐蚀性能的影响[J]. 石油化工高等学校学报, 2009, 22(4): 67-71.

SONG Yi-si， GAO Wan-fu， HU Zhuo-chan. Influence of Heat Treatment on Microstructure and Corrosion Resistant Performance of Inconel718 Nickel-Base Alloy[J]. Journal of Petrochemical Universities, 2009, 22(4): 67-71.

[1]	张琨,刘政军. 固溶处理对7075超硬铝焊接接头组织及力学性能的影响[J]. 石油化工高等学校学报, 2017, 30(6): 86-92.
[2]	崔一哲,李德元,娄建新. 高温时效对异质接头碳迁移和组织的影响[J]. 石油化工高等学校学报, 2013, 26(2): 58-62.
[3]	胡传顺,秦华,马喜龙,朱健. 二次热循环对2.25Cr1Mo钢组织的影响[J]. 石油化工高等学校学报, 2012, 25(3): 64-66.
[4]	王亚新,胡传顺,秦华,马喜龙. 三次热循环对2.25Cr1Mo钢组织的影响[J]. 石油化工高等学校学报, 2012, 25(2): 70-72.
[5]	吴敏. 微量铅对Sn-9Zn钎料组织及性能的影响[J]. 石油化工高等学校学报, 2012, 25(1): 66-70.
[6]	吴比,李增荣. 电弧喷涂铁基缸体涂层材料组织及耐磨性分析[J]. 石油化工高等学校学报, 2011, 24(5): 86-90.
[7]	孔祥军,陶思达. 加热炉炉管的安全评定及剩余寿命预测[J]. 石油化工高等学校学报, 2011, 24(4): 88-90.
[8]	马喜龙,胡传顺,秦华,蒋应田. 热处理工艺对2.25Cr1Mo0.25V钢相变温度的影响[J]. 石油化工高等学校学报, 2011, 24(3): 79-81.
[9]	王妍，栾江峰，吴敏，丁启敏. 元素Ag 对Sn －9Zn 钎料组织及性能影响[J]. 石油化工高等学校学报, 2010, 23(3): 79-82.
[10]	吴敏. 外加磁场对Sn-9Zn钎料组织、熔化温度及腐蚀性能影响[J]. 石油化工高等学校学报, 2010, 23(2): 80-83.
[11]	李昕,颜学峰. 基于SOM-PCA-RVM 的过程建模及其应用[J]. 石油化工高等学校学报, 2009, 22(4): 89-94.

热处理对Inconel718镍基合金组织及耐蚀性能的影响

Influence of Heat Treatment on Microstructure and Corrosion Resistant Performance of Inconel718 Nickel-Base Alloy

PDF

可视化

摘要/Abstract

引用本文

使用本文

参考文献

相关文章 11

编辑推荐

Metrics