石油化工高等学校学报

石油化工高等学校学报 ›› 2020, Vol. 33 ›› Issue (5): 24-29.DOI: 10.3969/j.issn.1006-396X.2020.05.005

• 石油工程 • 上一篇    下一篇

实际地层温度压力条件下的渗吸实验研究

曹庾杰1, 杨胜来1, 王君如1, 王梦雨1, 于家义2, 王敉邦1   

  1. 1. 中国石油大学(北京) 油气资源与探测国家重点实验室,石油工程教育重点实验室,北京 102249; 2. 中国石油吐哈油田公司 勘探开发研究院,北京 100083
  • 收稿日期:2019-04-12 修回日期:2019-04-28 出版日期:2020-10-30 发布日期:2020-11-12
  • 通讯作者: 杨胜来(1961⁃),男,博士,教授,从事油气渗流理论与应用及油气田开发理论与系统工程方面研究;E⁃mail:yangsl@.cup.edu.cn
  • 作者简介:曹庾杰(1994-),男,硕士研究生,从事低渗透油藏渗流机理方面研究;E-mail:1020019983@qq.com
  • 基金资助:
    国家自然科学基金(51574257);国家重点基础研究发展计划(973计划)(2015CB250904);中国石油天然气股份有限公司重大科技专项(2017E?0405

Experimental Study on Imbibition under Actual Reservior's Temperature and Pressure Conditions

Cao Yujie1, Yang Shenglai1, Wang Junru1, Wang Mengyu1, Yu Jiayi2, Wang Mibang1   

  1. 1. Key Laboratory of Oil and Gas Resoueces and Engineering,Key Laboratory of Petroleum Engineering of Ministry of Educaton,China University of Petroleum(Beijing),Beijing 102249,China; 2. Research Institute of Exploration and Development, PetroChina Tuha Oilfield Company,Beijing 100083,China
  • Received:2019-04-12 Revised:2019-04-28 Published:2020-10-30 Online:2020-11-12

摘要: 采用低渗透砂岩岩心进行实际地层温度压力条件下的渗吸实验,分析低渗透砂岩注水吞吐过程中的渗吸规律,并与常温常压渗吸实验进行了对比。实验表明,常温常压渗吸效率为18%~24%,平均为21%;前6 h岩心渗吸速率最快,为0.8~1.7 %/h。实际地层温度压力条件渗吸效率为24%~31%,平均为27%;第1轮次渗吸速率最快,为2.6~3.6 %/h。与常温常压渗吸相比,实际地层温度压力条件下能提升渗吸效率5%~7%,渗吸速率也明显高于常温常压渗吸,分析认为实际地层温度压力条件下可增加渗吸动力、减小渗吸阻力,更有利于发生油水置换。建立了渗吸深度理论计算模型,得出岩心渗吸波及的深度为0.25~0.63 cm,认为前期快速渗吸阶段进入的深度属于厘米级范围,渗吸深度随渗吸效率的增加而增加。综合研究认为,提高地层压力和进行大面积压裂可有效提高渗吸效率。

关键词: 低渗透砂岩, 注水吞吐, 常温常压渗吸, 渗吸深度

Abstract: The permeability and absorption experiments of low permeability sandstone core under the actual formation temperature and pressure were carried out,which were used to analyze the waterflooding huff⁃puff 's oil recovery law of imbibition and compared with imbibition experiments of normal temperature⁃pressure.The experiments show that the imbibition efficiency of normal temperature⁃pressure is 18%~24%,with an average of 21%.The permeability rate of core in the first six hours is the fastest,which is 0.8~1.7 %/h.The imbibition efficiency of actual reservior's temperature and pressure conditions is 24%~31%,with an average of 27%;Imbibition rate is the fastest in the first round,which is 2.6~3.6 %/h.Compared with imbibition of normal temperature⁃pressure,the imbibition of actual reservior 's temperature and pressure conditions can promote the imbibition efficiency by 5% to 7%,and the imbibition rate is also significantly higher than the imbibition of normal temperature⁃pressure.The analysis believes that imbibition of actual reservior 's temperature and pressure conditions can increase the imbibition's power and reduce the imbibition's resistance,which is more conducive to oil⁃water displacement.Furthermore,the theoretical calculation model of the imbibition depth is established, and the cores' imbibition depth is about 0.25~0.63 cm.It is considered that the depth of the early rapid imbibition stage is in the centimeter range,and the imbibition depth increases with the imbibition efficiency.According to the comprehensive research,increasing the reservior's pressure and large⁃area fracturing can effectively improve the imbibition efficiency.

Key words: Low permeability sandstone, Waterflooding huff?puff, Imbibition of normal temperature?pressure, Imbibition depth

引用本文

曹庾杰, 杨胜来, 王君如, 王梦雨, 于家义, 王敉邦. 实际地层温度压力条件下的渗吸实验研究[J]. 石油化工高等学校学报, 2020, 33(5): 24-29.

Cao Yujie, Yang Shenglai, Wang Junru, Wang Mengyu, Yu Jiayi, Wang Mibang. Experimental Study on Imbibition under Actual Reservior's Temperature and Pressure Conditions[J]. Journal of Petrochemical Universities, 2020, 33(5): 24-29.

使用本文