Reliability Analysis of Automobile Engine Connecting Rod Working in Tension and Compression Conditions

doi:10.3696/j.issn.1672-6952.2011.03.014

Journal of Liaoning Petrochemical University ›› 2011, Vol. 31 ›› Issue (3): 50-53.DOI: 10.3696/j.issn.1672-6952.2011.03.014

Previous Articles Next Articles

Reliability Analysis of Automobile Engine Connecting Rod Working in Tension and Compression Conditions

LIN Guo-qing， WANG Mao-ting*， LIN Meng

School of Mechanical Engineering，Liaoning Shihua University，Fushun Liaoning 113001， P.R.China

Received:2011-04-10 Published:2011-09-25 Online:2017-07-05

汽车发动机连杆在拉压工况下的可靠性分析

林国庆,王茂廷* ,林猛

辽宁石油化工大学机械工程学院,辽宁抚顺113001

作者简介:林国庆(1986-),男,吉林农安县,在读硕士。

Abstract

Abstract:

ANSYS finite element software was applied to analysis the stress of connecting rod working in tension and compression conditions to obtain the stress intensity distribution. The result show that the greatest stress is at the inner surface of the connecting rod small end hole and the maximum stress intensity value are 15.1 MPa and 161.0 MPa. Then using the ANSYS finite element software to analysis the reliability of connecting rod and Monte-Carlo method was chosen. According to that obtained the mean probability is 2.62% when the connecting rod in the 95 % confidence level and initial limit state Z<0(Z=σs-σ _max; in which σ_maxis the maximum stress occurred during the container used and σ s is yield strength of material).In other words, the reliability of the connecting rod is 97.38%, and acquire the load distribution histogram and sampling process picture of connecting rod, so it is safe. 

Key words: ANSYS , , Connecting rod , Tension and compression conditions , Reliability analysis , Confidence , Reliability

摘要： 利用ANSYS有限元软件对连杆结构进行应力分析,获得了连杆结构在拉压工况下的应力强度分布,
结果表明:该连杆在受拉压两种工况下最大等效应力出现在连杆小头孔的内表面上,拉压工况下其值分别为15.1
MPa和161.0MPa。然后利用ANSYS有限元软件中的蒙特卡罗法来分析连杆结构的可靠性,经过分析获得了连杆
结构在置信度为95%的情形下,初值极限状态Z<0(Z=σs-σmax,其中σmax为容器在使用过程中出现的最大应力,
σs 为材料的屈服强度)的概率平均值为2.62% ,即说明连杆的可靠度为97.38%,以及获得了该连杆结构的载荷分布
柱状图和屈服极限抽样过程图,通过分析可知:该连杆结构是安全可靠的。

关键词: ANSYS , , , 连杆结构 , , 拉压工况 , 可靠性分析 , , 置信度 , , , 可靠度

LIN Guo-qing，WANG Mao-ting，LIN Meng.

Reliability Analysis of Automobile Engine Connecting Rod Working in Tension and Compression Conditions

[J]. Journal of Liaoning Petrochemical University, 2011, 31(3): 50-53.

林国庆,王茂廷,林猛. 汽车发动机连杆在拉压工况下的可靠性分析[J]. 辽宁石油化工大学学报, 2011, 31(3): 50-53.

[1]	Liang Jiling，Wang Liqun，Liu Lijuan，Tian Li，Zhang Lunqiu，Wang Weiqiang. The Modification of Fe3O4@SiO2 by Silane Coupling Agent and Performance [J]. Journal of Liaoning Petrochemical University, 2019, 39(6): 21-26.
[2]	Wang Yan， Nie Hong. Synchronous H _∞ Stabilization of TimeDelay Switched Systems under Partially DelayDependent Controllers [J]. Journal of Liaoning Petrochemical University, 2018, 38(04): 93-100.
[3]	Yang Fan, Li Yongfeng. Research Progress in Preparation and Catalytic Performance of the Carbon-Based Non Noble Metal Catalysts [J]. Journal of Liaoning Petrochemical University, 2018, 38(02): 1-8.
[4]	Wang Guoliang， Yi Chenglong. Fault Dependency Detection Method Based on Random Occurrence of Fault Signal [J]. Journal of Liaoning Petrochemical University, 2018, 38(02): 71-79.
[5]	. Removal of Sulfides from Simulated Oil by CH₃CONH₂/ZnCl₂ Deep Eutectic Solvent [J]. Journal of Liaoning Petrochemical University, 2017, 37(5): 1-7.
[6]	LiuYujuan,XuJi,TongYufei,et al. Progress in Research of the Synthesis Methods of Nanometer Ceria [J]. Journal of Liaoning Petrochemical University, 2017, 37(5): 8-12.
[7]	Liu Jindong,He Xin,Xin Dingye,et al. Change Law of Four Fractions in Residue Hydrotreating Catalyst Grading System [J]. Journal of Liaoning Petrochemical University, 2017, 37(5): 13-16.
[8]	Fu Yu,Li Xiaoou,Li Heming,et al. Enhanced Removal of the Mechanical Impurities in OilSandsOil  from Indonesia by UltrasoundSedimentation Method [J]. Journal of Liaoning Petrochemical University, 2017, 37(5): 17-21.
[9]	Wu Hao， Ma Guiyang， Xiang Nan，et al. The Effect Analysis of Settlement of Soil on Stress Fields of  Horizontal Section of Crossing Pipeline Structure [J]. Journal of Liaoning Petrochemical University, 2017, 37(5): 22-25.
[10]	Yan Rongju， Wang Weiqiang， Li Zimeng，et al. Progress of Severe Slugging in Marine Riser System [J]. Journal of Liaoning Petrochemical University, 2017, 37(5): 26-30.
[11]	Wang Long. Application of Seismic Reconstruction Inversion in Prediction of River  Channel of X Development Zone in Daqing Placantieline [J]. Journal of Liaoning Petrochemical University, 2017, 37(5): 31-37.
[12]	Zhu Bomin. Optimization of Well Spacing in Gaotaizi Reservoir  of Sazhong Development Zone [J]. Journal of Liaoning Petrochemical University, 2017, 37(5): 38-43.
[13]	Ma Jing,Jin Kejun,Liang Yufeng,et al. Study on Comprehensive Evaluation for Engineering  Mode of Offshore Oil and Gas Fields [J]. Journal of Liaoning Petrochemical University, 2017, 37(5): 44-48.
[14]	Fan Dengshuai,Gao Peng, Liu Zhihui，et al. A Method of Connection Reliability Analysis of Bolted Flange Systems [J]. Journal of Liaoning Petrochemical University, 2017, 37(5): 49-52.
[15]	Wu Zhiyong,Liu Yang,Gao Yang,et al. An Investigation on the Time Relaxation Parameter Used in Boiling  Simulation of Helical Coil Heat Exchanger ShellSide [J]. Journal of Liaoning Petrochemical University, 2017, 37(5): 53-60.

Reliability Analysis of Automobile Engine Connecting Rod Working in Tension and Compression Conditions

汽车发动机连杆在拉压工况下的可靠性分析

PDF

Knowledge

Abstract

Cite this article

share this article

References

Related Articles 15

Recommended Articles

Metrics