辽宁石油化工大学学报 ›› 2023, Vol. 43 ›› Issue (1): 8-12.DOI: 10.12422/j.issn.1672-6952.2023.01.002

• 化学与化学工程 • 上一篇    下一篇

聚合物包裹纳米颗粒封堵剂的制备及其封堵性能

李华坤1(), 曾静1, 陈鑫1(), 高利华1, 赵志银2, 文婕2   

  1. 1.中国石油集团川庆钻探工程有限公司 国际工程公司,四川 成都 610000
    2.西南石油大学 化学化工学院,四川 成都 610500
  • 收稿日期:2021-10-06 修回日期:2021-12-02 出版日期:2023-02-25 发布日期:2023-03-13
  • 通讯作者: 陈鑫
  • 作者简介:李华坤(1975⁃),男,工程师,从事钻井液现场技术服务和研究;E⁃mail:lihuakun1021@163.com
  • 基金资助:
    油气田应用化学四川省重点实验室开放基金项目(YQKF202115)

Preparation of Polymer Encapsulated Nano Particle Plugging Agent and Its Plugging Performance

Huakun Li1(), Jing Zeng1, Xin Chen1(), Lihua Gao1, Zhiyin Zhao2, Jie Wen2   

  1. 1.International Engineering Company,CNPC Chuanqing Drilling Engineering Co. Ltd. ,Chengdu Sichuan 610000,China
    2.College of Chemistry and Chemical Engineering,Southwest Petroleum University,Chengdu Sichuan 610500,China
  • Received:2021-10-06 Revised:2021-12-02 Published:2023-02-25 Online:2023-03-13
  • Contact: Xin Chen

摘要:

页岩水化和分散导致井壁失稳一直是油气钻井工程中的难题,通过纳米封堵剂物理封堵页岩中的孔隙和微裂缝,是提高页岩地层稳定性最好的方法。采用硅烷偶联剂KH560对高浓度的硅溶胶进行改性处理,运用无皂乳液聚合原理,在改性SiO2粒子表面接枝丙烯酸(AA)和苯乙烯(St)单体,成功研制出一种聚合物包裹纳米颗粒的新型弹性承压封堵剂。通过Zeta电位及粒度分析仪和透射电子显微镜证明所制备的STA?1封堵剂粒径中值为45.3 nm。以中压滤失量为评价指标得到最佳合成条件:反应温度为60 ℃,反应时间为3.0 h,m(St)/m(AA)=3∶2,分散搅拌时间为10.0 min,单体质量分数为6.67%,引发剂质量分数为0.40%。最后,利用岩心驱替实验模拟页岩考察STA?1的实际封堵效果。结果表明,质量分数为1.00%的STA?1对渗透率小于2 000 mD的填砂管表现出良好的堵水能力,封堵率大于85%。

关键词: 硅溶胶, 丙烯酸, 苯乙烯, 纳米封堵剂

Abstract:

Shale hydration and dispersion lead to instability of the borehole wall, which has always been a problem in oil and gas drilling engineering. Physically plugging pores and micro?cracks in shale through nano plugging agents is the best way to improve the stability of shale formations. In this work, the silane coupling agent KH560 was used to modify the high?concentration silica sol. The principle of soap?free emulsion polymerization was used in combination with solvothermal synthesis to graft acrylic acid (AA) and styrene (St) monomers on the surface of modified SiO2 particles. Thus, a new type of elastic pressure?bearing plugging agent with polymer?encapsulated nanoparticles was successfully developed. Taking medium pressure filter loss as the evaluation index, the best synthesis conditions were obtained: The reaction temperature was 60 ℃, the reaction time was 3.0 h, the monomer ratio was 3∶2, the pre?emulsification time was 10.0 min, the total monomer mass was 6.67%, and the amount of initiator was 0.40%. In addition, Zeta potential, particle size analyzer and transmission electron microscope proved that the median particle size of the prepared STA?1 plugging agent was 45.3 nm. Finally, a core displacement experiment was used to simulate the shale layer to investigate the actual plugging effect of STA?1. The results revealed that 1.00% STA?1 showed good water plugging ability for sand filled pipes with permeability below 2 000 mD, and the plugging rate was higher than 85%.

Key words: Silica sol, Acrylic acid, Styrene, Nano?plugging agent

中图分类号: 

引用本文

李华坤, 曾静, 陈鑫, 高利华, 赵志银, 文婕. 聚合物包裹纳米颗粒封堵剂的制备及其封堵性能[J]. 辽宁石油化工大学学报, 2023, 43(1): 8-12.

Huakun Li, Jing Zeng, Xin Chen, Lihua Gao, Zhiyin Zhao, Jie Wen. Preparation of Polymer Encapsulated Nano Particle Plugging Agent and Its Plugging Performance[J]. Journal of Liaoning Petrochemical University, 2023, 43(1): 8-12.

使用本文

0
    /   /   推荐

导出引用管理器 EndNote|Ris|BibTeX

链接本文: https://journal.lnpu.edu.cn/CN/10.12422/j.issn.1672-6952.2023.01.002

               https://journal.lnpu.edu.cn/CN/Y2023/V43/I1/8