石油化工高等学校学报

石油化工高等学校学报 ›› 2014, Vol. 27 ›› Issue (6): 83-87.DOI: 10.3969/j.issn.1006-396X.2014.06.017

• 油气储运 • 上一篇    下一篇

多孔滤膜抽滤法测定原油沥青质含量

刘 闯1, 2韩善鹏1陈普敏1, 2   

  1. ( 1. 中国石油大学( 北京) 油气管道输送安全国家工程实验室和城市油气输配技术北京市重点实验室, 北京1 0 2 2 4 9;
    2. 新疆石油勘察设计研究院有限公司, 新疆克拉玛依8 3 4 0 0 0)
  • 收稿日期:2013-09-24 修回日期:2014-01-12 出版日期:2014-12-25 发布日期:2014-12-19
  • 通讯作者: 韩善鹏( 1 9 8 2 - ) , 男, 博士, 讲师, 从事油气长距离管输技术研究; E - m a i l : s h a n p e n g h a n@1 6 3. c o m。
  • 作者简介:刘闯( 1 9 8 7 - ) , 女, 硕士, 助理工程师, 从事油气长距离管输技术研究; E - m a i l : l i u c h u a n g 1 9 8 8 0 4 0 9@1 6 3. c o m。
  • 基金资助:
    国家自然科学基金项目( 5 1 1 3 4 0 0 6, 5 1 2 0 4 1 9 4) ; 中国石油大学( 北京) 基金资助项目( KY J J 2 0 1 2 - 0 4 - 0 6)

Measurement of the Asphaltene Content in Crude Oil Using Suction Microfiltration Method

  1. (1.National Engineering Laboratory for Pipeline Safety and Beijing Key Laboratory of Urban Oil and Gas Distribution Technology,China University of Petroleum(Beijing), Beijing 102249,China;2. Xinjiang Petroleum Survey and Design Institute (Co., Ltd.), Karamay Xinjiang 834000, China)
  • Received:2013-09-24 Revised:2014-01-12 Published:2014-12-25 Online:2014-12-19

摘要: 对测定原油沥青质含量的3种分离方法( 离心法、 抽滤法、 过滤法) 进行对比, 观察到抽滤法在安全健 康、 效率及重复性等方面具有明显优势。采用激光纳米粒度分析仪对3种分离方法的残液进行了粒度分析, 结果表 明, 过滤法将导致较多的沥青质颗粒的损失, 造成测量结果偏小。在此基础上, 对抽滤法测试流程中涉及的剂油比、 样品静置时间、 取样量等影响因素进行优选, 确定出适宜剂油比为4 0mL / g、 静置时间3 0m i n、 取样质量1. 0g。与 S Y / T7 5 5 0—2 0 0 4标准方法相比, 采用多孔滤膜抽滤法测定原油沥青质含量, 推荐的参数合理, 测试精度较高。

关键词: 原油, 沥青质含量, 抽滤

Abstract: The three separation methods (centrifugation, filtration and suction microfiltration) for measuring the asphaltenes content in crude oil were compared in this work. The suction microfiltration method was found having significant advantages in operationsafety, separationefficiency and repeatability in measured values. In order to find the difference among these three methods, the residual particles in the supernatant or filtrate was measured using a laser particle analyzer. The results show that, the filtration method will result in more loss of asphaltenes particles than other methods. Several factors has been optimized for the suction method such as the blending time (30 min), the ratio of precipitant to oil (40 mL/g), and the sampling mass (1.0 g). Compare with the standard SY/T 7550—2004, the optimized measurement conditions in this study are reasonable and the test accuracy is acceptable. 

Key words: Crude oil,    ,  Asphaltene yield,    ,  Suction microfiltration

引用本文

刘 闯, 韩善鹏, 陈普敏. 多孔滤膜抽滤法测定原油沥青质含量[J]. 石油化工高等学校学报, 2014, 27(6): 83-87.

Liu Chuang,Han Shanpeng,Chen Pumin. Measurement of the Asphaltene Content in Crude Oil Using Suction Microfiltration Method[J]. Journal of Petrochemical Universities, 2014, 27(6): 83-87.

使用本文