辽宁石油化工大学学报 ›› 2012, Vol. 32 ›› Issue (2): 78-83.

• 其他学科 • 上一篇    下一篇

精益造船中计划约束下的拉动式生产控制方法

宗鸣镝孙厚芳   

  1. 北京理工大学机械与车辆工程学院,北京100081
  • 收稿日期:2011-12-10 出版日期:2012-06-25 发布日期:2017-07-06
  • 作者简介:宗鸣镝(1978-),男(满),辽宁兴城市,工程师,在读博士
  • 基金资助:
    国防科工局技术基础资助项目(C172009C001)

A Pull-Way Production Control Method With  Restriction of Plan for Lean Shipbuilding

ZONG Ming-di, SUN Hou-fang   

  1. school of Mechanical and Automobile Engineer, Beijing Institute of Technology, Beijing 100081, P.R.China
  • Received:2011-12-10 Published:2012-06-25 Online:2017-07-06

摘要:      分析了传统“拉动式”生产控制方法在造船行业应用的问题,针对造船行业项目性管理的特点,提出了“项目计划约束下的拉动式控制方法”。该方法基于企业产能具备自我调节能力的前提下,通过“强制投产”原则与看板(KANBAN)控制原理的结合,达到在制品数量控制与项目进度控制的平衡。最后,通过计算机仿真对本文的控制方法与KANBAN式生产控制方法和推动式生产控制方法进行了对比分析。

关键词: 精益生产 ,  造船 ,  拉动式生产 ,  项目进度控制

Abstract: The issues of utilizing the traditional “pull-way” production control method for shipbuilding were investigated. Considering the project management character at shipbuilding, a pull-way production control method with restriction of project plan was raised. This method assumes the production capacity of the enterprise can be self-adjusted based on the progress. A “mandatory production command” controlling principle was introduced into the KANBAN control process, which can balance the WIP control and the project progress control target. The result of a computer simulation program was introduced at the end of the paper, which compared the result of the suggested control method with that of KANBAN control method and push production control method. 

Key words: Lean manufacturing , Shipbuilding , Pull-way production , Project progress control

引用本文

宗鸣镝,孙厚芳. 精益造船中计划约束下的拉动式生产控制方法[J]. 辽宁石油化工大学学报, 2012, 32(2): 78-83.

ZONG Ming-di, SUN Hou-fang. A Pull-Way Production Control Method With  Restriction of Plan for Lean Shipbuilding[J]. Journal of Liaoning Petrochemical University, 2012, 32(2): 78-83.

使用本文

0
    /   /   推荐

导出引用管理器 EndNote|Ris|BibTeX

链接本文: https://journal.lnpu.edu.cn/CN/

               https://journal.lnpu.edu.cn/CN/Y2012/V32/I2/78