Journal of Petrochemical Universities

Journal of Petrochemical Universities ›› 2011, Vol. 24 ›› Issue (6): 93-96.DOI: 10.3696/j.issn.1006-396X.2011.06.023

Previous Articles    

Deformation Identifying of the Horizontal-Type Elliptic Cylindrical Oil  Tank and Tank Capacity Calibration Model
 

  

  1. 1.Department of Computer Science, Yan’an University, Yan’an Shaanxi 716000,P.R.China; 2. Software Research and Development Center, Yan’an University, Yan’an Shaanxi 716000,P.R.China; 3.State Key Laboratory of Information Security, Institute of Software, The Chinese Academy of Sciences, Beijing 100080,P.R.China
  • Received:2011-09-06 Published:2011-12-25 Online:2011-12-25

卧式椭圆柱型储油罐的变位识别与罐容标定

王文发1,2,马燕1,2,田云娜1,2,李红达3   

  1. 1.延安大学计算机学院;2.延安大学软件研究与开发中心;3.中国科学院软件研究所信息安全国家重点实验室
  • 作者简介:王文发(1968-),男,陕西志丹市,副教授,硕士
  • 基金资助:
    国家自然科学基金资助项目(60970139)

Abstract: In order to solve the error problems of tank capacity measurement caused by oil tank deformation, the after tank oil of horizontal-type elliptic cylindrical oil were recalibrated. The corresponding calibration model are established and tank capacity calibration formula are also built when oil tank in horizontal and inclined position. Meanwhile, model solution steps are given.The model are tested through the examples, the test results have confirmed the correctness and the feasibility of the model.

Key words: Deformation, Identification, Tank capacity, Calibration, Model

摘要: 为了解决由于储油罐变位而导致的罐容表计量误差问题,对卧式椭圆柱型储油罐变位后罐内油量进
行了重新标定,建立了相应的标定模型和储油罐在水平和倾斜放置时的罐容标定公式,并给出了模型的求解步骤。
通过实例对模型进行检验,检验结果验证了模型的正确性和可行性。

关键词: 变位 , 识别 , 罐容 , 标定 , 模型

Cite this article

WANG Wen-fa,MA Yan,TIAN Yun-na,et al.

Deformation Identifying of the Horizontal-Type Elliptic Cylindrical Oil  Tank and Tank Capacity Calibration Model
 
[J]. Journal of Petrochemical Universities, 2011, 24(6): 93-96.

王文发,马燕,田云娜,李红达. 卧式椭圆柱型储油罐的变位识别与罐容标定[J]. 石油化工高等学校学报, 2011, 24(6): 93-96.