石油化工高等学校学报

石油化工高等学校学报 ›› 2015, Vol. 28 ›› Issue (6): 44-48.DOI: 10.3969/j.issn.1006-396X.2015.06.009

• 石油工程 • 上一篇    下一篇

基于正交设计与统计分析的注水井储层伤害预测

乔文波1, 2,  李海涛2,  张富畋1,  张 岭3,  张 美2,  李龙飞2   

  1.             
    ( 1. 中国石油长庆油田第七采油厂, 甘肃庆阳7 4 5 0 0 0; 2. 西南石油大学油气藏地质及开发工程国家重点实验室,
    四川成都6 1 0 5 0 0; 3. 中海石油( 中国) 有限公司天津分公司, 天津3 0 0 4 5 2)
  • 收稿日期:2013-12-17 修回日期:2015-03-12 出版日期:2015-12-25 发布日期:2015-12-07
  • 作者简介:乔文波( 1 9 8 9 - ) , 男, 硕士研究生, 从事油气田开发方面研究; E - m a i l : q i a o w b 3 3 0@a l i y u n. c o m。
  • 基金资助:
    中国海洋石油( 中国) 有限公司项目“ 中国近海低孔低渗油气藏勘探开发关键技术与实践” ( CNOOC - S Y - 0 0 1) 和“ 低
    渗油田注水水质综合评价与注水剖面均衡控制研究” ( C C L 2 0 1 2 T J P Z T S 0 3 8 0) 。

Prediction of Formation Damage of Water Injection Well Based on Orthogonal Design and Statistical Analysis

  1. (1.Changqing Oilfield Company Oil Production Plant No.7, CNPC, Qingyang Gansu 745000,China;  2.State Key Laboratory of Oil and Gas Reservoir Geology and Exploitation, Southwest Petroleum University, Chengdu Sichuan 610500,China; 3.Tianjin Branch of CNOOC China Limited, Tianjin 300452, China)
  • Received:2013-12-17 Revised:2015-03-12 Published:2015-12-25 Online:2015-12-07

PDF

摘要： 通过对地层系数的计算统计明确了 QK油田主力注水层位分布。综合考虑, 取渗透率约为20 0 0mD 的1 5块岩心进行了模拟注水实验, 以岩心渗透率伤害率为指标, 采用正交试验法, 考察了颗粒粒径、 颗粒质量浓度以 及含油质量浓度等因素对伤害率的影响。各因素效应计算表明, 对伤害率影响从大到小依次为含油质量浓度、 颗粒 质量浓度、 颗粒粒径。同时应用统计分析方法对其余条件下的伤害率做了预测, 得到了真实值与预测值之间的误差 范围, 并得以验证。结果显示注水最优条件: 颗粒粒径、 颗粒质量浓度与含油质量浓度分别为4μm、 3m g / L和1 8 m g / L或4μm、 7m g / L与1 5m g / L, 伤害率分别为2 2. 5%及2 5. 0%。

关键词: 储层伤害,  , 注水, 正交设计, 统计分析, 预测

Abstract: A calculation of formation capacity in QK oilfield was carried out to identify the distribution of main water injection layers. A comprehensive core flowing test based on orthogonal design with 15 core samples (2 000 mD approximately) was carried out and the core permeability damage rate indicated that the damage degree was caused by particle size distribution, concentration and oil concentration. Take all these factors into consideration, the impact on the damage degree in decreasing order was oil concentration, particle concentration and particle size. Meanwhile damage rate was predict applying statistical analysis under other conditions then the error range between the predictive value and the true value, was obtained and verified. The results can be concluded that when particle size, concentration and oil concentrations were of 4 μm, 3 mg/L and 18 mg/L or 4 μm, 7 mg/L and 15 mg/L, damage rate were 22.5% and 25%.

Key words: Formation damage,    , Water injection,    ,  Orthogonal design,    ,  Statistical analysis,     , Prediction

引用本文

乔文波, 李海涛, 张富畋, 张 岭, 张 美, 李龙飞. 基于正交设计与统计分析的注水井储层伤害预测[J]. 石油化工高等学校学报, 2015, 28(6): 44-48.

Qiao Wenbo,Li Haitao,Zhang Futian,et al. Prediction of Formation Damage of Water Injection Well Based on Orthogonal Design and Statistical Analysis [J]. Journal of Petrochemical Universities, 2015, 28(6): 44-48.

使用本文

0
    /   /   推荐

导出引用管理器 EndNote|Ris|BibTeX

链接本文: http://journal.lnpu.edu.cn/syhg/CN/10.3969/j.issn.1006-396X.2015.06.009

               http://journal.lnpu.edu.cn/syhg/CN/Y2015/V28/I6/44



网站版权 © 2021《石油化工高等学校学报》编辑部

本系统由北京玛格泰克科技发展有限公司设计开发