辽宁石油化工大学学报

辽宁石油化工大学学报 ›› 2005, Vol. 25 ›› Issue (3): 11-13.

• 石油化工 • 上一篇    下一篇

丁酮-甲苯法测定高含油蜡中的含油量

李丽华1 , 王丽君2 , 蔡秀党2 , 张金生1 *   

  1. 1, 辽宁石油化工大学石油化工学院, 辽宁抚顺113001;
    2, 抚顺石油化工研究院, 辽宁抚顺113001
  • 收稿日期:2004-12-24 出版日期:2005-03-25 发布日期:2005-03-25
  • 作者简介:李丽华(1964 -), 女, 辽宁抚顺市, 教授, 在读博士

Determination of High Oil Content in Petroleum Wax by the Butanone -Toluene Method

  1. 1 .School of Petrochemical Technology , Liaoning University of Petroleum & Chemical Technology , Fushun Liaoning 113001 ,P .R .China ;
    2 .Fushun Research Institute of Petroleum and Petrochemicals , Fushun Liaoning 113001 , P .R .China
  • Received:2004-12-24 Published:2005-03-25 Online:2005-03-25

摘要:         对丁酮-甲苯法测定石油蜡的含油量进行了研究。通过实验, 考察了样品取样质量、空气流速对实验结果的影响。同时对该方法的重复性进行验证, 并对国内部分石油蜡产品进行了含油量测定实验。结果表明, 丁酮-甲苯法有很好的重复性和实用性, 用于对石蜡中的含油量的测定, 可以检测油的质量分数为15 %~ 55 %的石油蜡。采用国产设备和试剂代替进口设备和试剂, 降低了实验费用。

关键词: 石油蜡,  含油量,  丁酮-甲苯法,  标准

Abstract:

        Determination of oil content in petroleum w ax (butanone -to luene method)was studied .The effects of mass of samples,air current velocity on test results were researched in the experiment .Repetitiveness of the method was validated, and the oil content of some domestic pro ducts of petroleum w ax w as measured with the butanone -toluene method .The results show that this method has good repetitiveness and practicability .The mass fraction of oil in petroleum wax from 15 % to 55 % can be determined.This method dramatically decreases the cost of determination by using the domestic apparatuses and reagents instead of imported ones.

Key words: Petro leum wax , Oil content , Butanone -toluene method, Standard

引用本文

李丽华, 王丽君,蔡秀党,张金生. 丁酮-甲苯法测定高含油蜡中的含油量[J]. 辽宁石油化工大学学报, 2005, 25(3): 11-13.

LI Li -hua,WANG Li -jun,et al. Determination of High Oil Content in Petroleum Wax by the Butanone -Toluene Method[J]. Journal of Liaoning Petrochemical University, 2005, 25(3): 11-13.

使用本文

0
    /   /   推荐

导出引用管理器 EndNote|Ris|BibTeX

链接本文: http://journal.lnpu.edu.cn/CN/

               http://journal.lnpu.edu.cn/CN/Y2005/V25/I3/11